Abstract
Nowadays, data transmission is commonly used & No logistic delivery is involved. But the actual models are still required in the subsequent process. Thus either virtual intraoral scanning data or impression scanning data is required for model creation and printing with 3D printer
Implant is one of the most common restoration types that adopt either intraoral scan or impression scan to acquire data for following digital design and printing.
1.Data acquisition
Utilize AutoScan DS-EX Dental 3D Scanner（impression scan） to obtain the “jaw scan” data.
*Note: make sure the characteristic face is in the buccal or lingual side for complete acquisition
2.Load 3D data
Open exoCAD software and click “Load ”then select to load the data
Data requirement:
A. Upper jaw and lower jaw should be in occlussion & Scanbody is captured completely
B. Adjacent teeth should be redefined into antagonist after loading the data
3.Design
3. Print & Assembly
1. Place the Analog
2. Place gingiva mask
3. Assemble the simple articulator
4. Complete
Solution for 3D implant Model
